Sntp Commands - D-Link DES-3250TG Command Line Interface Reference Manual

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
SNTP C
The Simple Network Time Protocol (SNTP) (an adaptation of the
Network Time Protocol (NPT)) commands in the Command Line
Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config sntp primary <ipaddr>
secondary <ipaddr>
poll-interval <int 30-99999>
enable sntp
disable sntp
show sntp
Each command is listed, in detail, in the following sections.
24
OMMANDS
292