Table of Contents
Advertisement
28
A – Telephone operation:
4.6
Messages
Message texts can be sent between telephones connected to the ISDN
network. The function can only be used if it is available for your ISDN line!
Additionally, this ISDN service must be activated at your SmartLine D750:
See part A, section 5.12.
Receiving
A received message is shown in the display after ending the call. In the
messages
case of texts longer than 24 characters, you can view "more" of it in the
display by pressing the O.K. key.
Sending
-
a message
Select message -
If the selection described above is performed during a call, the text is
transferred at the end of the call.
The message can also be selected before the call. This is then transferred at
the next call that you make.
The selection of a text can be deleted again. Deletion of the selection is only
offered where a message has been previously selected.
-
Leaving
-
messages
for callers
Switch on or off -
Select message -
Changing
Existing message texts can be changed (maximum length: 32 characters).
message
Entry/ depiction of special characters: e.g. Ä, Ö, Ü =
texts
–-
Select message -
Delete current text -
4 Comfort functions
-
View more of the message -
-
-
–
-
/
-
View more of the message -
,
,
.
-
-
confirm change
enter new text -
Store
A – Telephone operation:
4.7
Barriers
You can specify the possibilities for outgoing calls and for programming by
setting up barriers. You can find out how to restrict incoming calls in the
section "Call filters".
The setting up of barriers is protected by a PIN (Personal Identification
Number).
4.7.1
Hot line
With the hot line function activated, only the automatic dialing of one single
telephone number is possible (e. g. in an emergency). The telephone num-
ber is dialed after lifting the handset and subsequently pressing any key.
Manual dialing is not possible. Telephone number memories cannot be
used. The telephone can, however, continue to be called.
The hot line has priority over all other set-up barriers: This means that it is
also performed with the dial bar activated, for example.
Entering/
-
changing
the hot line
Enter PIN -
number
(
delete a possibly existing hot line number)
Input tel. number -
Switch on
-
hot line
Enter PIN -
Switch on hot line -
Hot line is switched on: The corresponding symbol is displayed.
When switching off, the handset must be on hook!
Switch off
-
-
hot line
Enter PIN-
Switch off hot line -
4 Comfort functions
-
-
-
store input
-
-
store setting
–
store setting
29
Advertisement
Table of Contents
