Platform Event Trap Configuration Page - HP ProLiant DL140 User Manual

30 HP ProLiant DL140 and HP ProLiant DL145 Lights-Out 100i Remote Management
User Guide
Initially, there are no entries in the Current PEF Entries section because no PEFs
have been defined. When PEF entries are defined, the PEF Control field is active
and allows individual entries to be enabled, disabled, and deleted.
The Add PEF Entry section contains two main subsections:
•
Event Offsets are trip points (movements across thresholds) that define what
type of sensor event triggers an action. The information in this section varies
from sensor to sensor. Not all checkboxes are available for all sensors. You
can select any of the available checkboxes.
•
PEF Action has the same information for all sensors:
– Sensor Type (in this case, it is "Fan").
– Sensor Name (in this case, it is "CPU0 FAN").
– PEF Action. This dropdown menu enables you to select from Power Off
– PEF Control. This setting allows you to enable or disable each sensor.
– Alert Policy. This dropdown menu, by default, shows No Alert Policy if
– Add. This button adds the new entry to the PEF Current Entry table at the

Platform Event Trap Configuration page

The PET Configuration page enables an alarm or specified condition originating
on the ProLiant DL140 or ProLiant DL145 G2 server to alert a systems
management console that supports IPMI 1.5.
To access this page from a web browser, click PET Configuration on the main
menu navigation bar.
(selected for this example), Power Cycle, Hard Reset, and Send Alert
(requires a systems management console supporting IPMI 1.5).
alerts are not defined on the PET Configuration page (as in this example).
If alerts are defined in the PET Configuration page, then you can select
from your defined alert policies for this particular sensor and PEF.
top of the page.