Panasonic BT-M2090Y Service Manual page 10

_.
0
SET-UP FOR MONITOR INSTALLATION (continued)
STATUS DISPLAY (setting the status display to on/off) -
When the power is turned on or the Input mode is switched, the
status display (colour system and input mode) appear!I on screen. The
display can be set to on or off.
Setting
ON
OFF
Function
Status display appears.'
Status display does not appear.
CONTROL LOCK {deactivation of front-control functions) -
e
Set CONTROL LOCK to ON on screen to deactivate the front-control
functions (front VOLUME control and remote volume control are
operable).
Setting Function
ON
Deactivates the front controls
(except front/remote volume controls).
OFF Releases deactivated functions.
• If you attempt to operate a locked
function, "CONTROL LOCK ONI!"
appears on screen for approx. 2
seconds
to
Indicate the funcllon
cannot be operated.
e
Once CONTROL LOCK Is deacti-
vated, the current settings of the
front~control knobs and buttons are
activated.
• If the power is turned off with
CONTROL LOCK activated, the
function is kept in memory.
PICTURE SETTING INITIALISATION
MENU and/or SET-UP MENU settings including added changes can be reset (initialised)
to their factory-preset conditions.
To initialise MENU settings only
MENU settings (except MEMORY MODE and RGB/COMPO(SDI)) can
be exclusively reset:
1.
With the Y button pressed, press the MENU button to display (jJ on screen.
2. •
Press the ENTER button to reset.
• Press the
-4
or II>- b utton to cancel.
To initialise both MENU/SET-UP MENU settings--
MENU and SET-UP MENU settings other than MEMORY MODE and
RGB/COMPO(SDI) can be reset at the same time.
1.
Press the POWER switch to turn the power off.
2.
With the 'f' and MENU buttons pressed, press the POWER switch to turn
the power on. Keep pressing the 'f' and MENU buttons until
111
appears on
screen.
3.
Press the A or 'f' button to select SET-UP MENU RESET. Then press the
ENTER button to display
rn
on screen.
4. •
Press the ENTER button again to execute.
• Press the
-4
or
II>-
b utton to cancel.
*
The function of "ID NOMBER SET"' can't use.
e
• For
factory-presets on the
MENU
"MENU
DISPLAY
CHARl".
<MENU> RESET
Are you sure ?
"Vea" then g}
"No" then
llor8
(jJ
<INITIALIZE MENU>
ID NUMBER SET
ll><SET-UPMENU> RESET
llllm
[gJ
<SET-UP MENU) RESET
Are you sure?
"Yes" then
lg
"No" then
lfor8
rn
DI
~
s:
N
~
-<