ADSL C
ONFIGURATION
This section describes the default settings and operation of the NetScreen-5GT Wireless
ADSL Annex A and B devices as they are shipped from the factory. These default settings
are such that, in most cases, there are only a few items that you must configure.
This section describes the following configurations for the Untrust zone interface:
•
Configuring the ADSL Interface
•
VPI/VCI and Multiplexing Method
•
PPPoE or PPPoA
•
Annex B Mode
•
Configuring a Backup Untrust Zone Interface
•
Static IP Address and Netmask
Note: If you have any problems completing a configuration and you need to restore the
device to its default settings, see
The figure below shows the default configuration for the NetScreen-5GT Wireless ADSL.
Telephone
Outlet
ADSL Interface
(adsl1)
The ADSL interface has the predefined name "adsl1" and is the main connection from
your network to the Internet. To allow the NetScreen device (and the devices on your
network) to connect to the Internet, you must configure the adsl1 interface according to
information obtained from your service provider. Refer to
Interface" on page
NetScreen-5GT Wireless
"Resetting the Device to Factory Defaults" on page
To Internet
wireless1 interface
wireless2 Interface
192.168.2.1/24
Trust Interface
192.168.1.1/24
Hub
20.
Trust Zone
"Configuring the ADSL
ADSL Configuration
29.
Wzone1
19