Juniper NetScreen-5GT Wireless User Manual page 2

Copyright Notice
Copyright © 2005 Juniper Networks, Inc. All rights reserved.
Juniper Networks, the Juniper Networks logo, NetScreen, NetScreen Technologies, GigaScreen, and the NetScreen logo
are registered trademarks of Juniper Networks, Inc. NetScreen-5GT, NetScreen-5XP, NetScreen-5XT, NetScreen-25,
NetScreen-50, NetScreen-100, NetScreen-204, NetScreen-208, NetScreen-500, NetScreen-5200, NetScreen-5400,
NetScreen-Global PRO, NetScreen-Global PRO Express, NetScreen-Remote Security Client, NetScreen-Remote VPN
Client, NetScreen-IDP 10, NetScreen-IDP 100, NetScreen-IDP 500, GigaScreen ASIC, GigaScreen-II ASIC, and
NetScreen ScreenOS are trademarks of Juniper Networks, Inc. All other trademarks and registered trademarks are the
property of their respective companies.
Information in this document is subject to change without notice.
No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any
purpose, without receiving written permission from:
Juniper Networks, Inc.
ATTN: General Counsel
1194 N. Mathilda Ave.
Sunnyvale, CA 94089-1206
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
against harmful interference in a residential installation. This equipment generates, uses and can
reasonable protection against harmful interference when the equipment is operated in a commercial environment. The
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
cause harmful interference to radio communications. However, there is no guarantee that interference
residential area is likely to cause harmful interference, in which case users will be required to correct the interference at
will not occur in a particular installation. If this equipment does cause harmful interference to
their own expense.
radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
The following information is for FCC compliance of Class B devices: The equipment described in this manual generates
-Reorient or relocate the receiving antenna. and may radiate radio-frequency energy. If it is not installed in accordance with NetScreen's installation instructions, it
may cause interference with radio and television reception. This equipment has been tested and found to comply with the
-Increase the separation between the equipment and receiver.
limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
designed to provide reasonable protection against such interference in a residential installation. However, there is no
connected.
guarantee that interference will not occur in a particular installation.
-Consult the dealer or an experienced radio/TV technician for help.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
• Reorient or relocate the receiving antenna.
interference received, including interference that may cause undesired operation.
• Increase the separation between the equipment and receiver.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
• Consult the dealer or an experienced radio/TV technician for help.
compliance could void the user's authority to operate this equipment.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
IMPORTANT NOTE:
Caution: Changes or modifications to this product could void the user's warranty and authority to operate this device.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Disclaimer
This equipment should be installed and operated with minimum distance 20cm between the radiator & your
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH
body.
IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY
This transmitter must not be co-located or operating in conjunction with any other antenna or
THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY,
transmitter.
CONTACT YOUR JUNIPER NETWORKS REPRESENTATIVE FOR A COPY.
Juniper declared that NS-5GT-WIRELESS ADSL A is limited in CH1~11 from 2400 to 2483.5 MHz by specified
firmware controlled in USA.
Industry Canada Statement
Operation is subject to the following two conditions:
1) this device may not cause interference and(2) this device must accept any interference, including
interference that may cause undesired operation of the device
This device has been designed to operate with an antenna having a maximum gain of 6 dBi.
Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the EIRP is not more than required for successful communication.
To prevent radio interference to the licensed service, this device is intended to be operated indoors
and away from windows to provide maximum shielding.Equipment (or its transmit antenna) that is installed
outdoors is subject to licensing.