Visible Light Camera Module (Vlcm); Enabling/Disabling Visible Light Camera Module; Using Image Alignment - Fluke TiR2 User Manual

Visible Light Camera Module (VLCM)

Enabling/Disabling Visible Light Camera
Module
To enable/disable the visible light camera module:
1. Tap F.
2. Use the mouse controller to position the pointer over Camera Settings on
the popup menu and tap E.
3. Position the pointer over the VLCM tab and tap E.
You may need to position the pointer over the right or left arrow and tap
E to scroll to the VLCM tab.
4. Position the pointer over the Enable Visible Light Camera box; tap E
to add or remove a check mark. A check mark indicates the function is
enabled.
5. Tap to accept setting change and return to scan target mode.

Using Image Alignment

Image alignment is an automatic adjustment that occurs as you focus the
infrared camera lens. This feature is only available with the 20-mm lens. The
visible light image and the infrared image are lined up based on the focusing
distance of the infrared lens so that they may be combined for viewing and
analysis. The visible light image and the infrared image are lined up for
distances greater than 50 cm (approximately 2 ft).
Image alignment is disabled when using the optional 10 and 54-mm lenses. To
ensure proper image alignment with the standard 20-mm lens, the lens must be
aligned correctly when you install it on the camera. Correct alignment is
achieved by installing the lens such that the white alignment marking on the
lens lines up with the corresponding mark on the camera housing as shown in
Figure 5-1.
info@Fluke-Direct.com
Fluke-Direct
Chapter 5
.com
1.888.475.5235
5-1