Dodge Viper2017 User Manual page 56

O P E R A T I N G Y O U R V E H I C L E
To Set A Desired Speed
Turn the Speed Control on. When the vehicle has reached the desired speed, push the
SET (-) button and release. Release the accelerator and the vehicle will operate at the
selected speed.
NOTE:
The vehicle should be traveling at a steady speed and on level ground before pushing the
SET (-) button.
To Deactivate
A soft tap on the brake pedal, pushing the CANCEL button, manually accelerating 10 mph
(16 km/h) above the set speed or normal brake pressure while slowing the vehicle will
deactivate the Speed Control without erasing the set speed memory.
Pushing the ON/OFF button, or turning the ignition switch OFF, erases the set speed
memory.
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume can be
used at any speed above 20 mph (32 km/h).
To Vary The Speed Setting
To Increase Speed
When the Speed Control is set, you can increase speed by pushing the RES (+) button.
The driver's preferred units can be selected through the Uconnect settings if equipped.
Refer to "Uconnect Settings" in "Understanding Your Instrument Panel" in the Owner's
Manual at www.dodge.com/en/owners/manuals for more information. The speed incre-
ment shown is dependent on the selected speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the RES (+) button once will result in a 1 mph increase in set speed. Each
subsequent tap of the button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
Metric Speed (km/h)
• Pushing the RES (+) button once will result in a 1 km/h increase in set speed. Each
subsequent tap of the button results in an increase of 1 km/h.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
54