Dodge Viper2017 User Manual page 45

8. If the child restraint has a top tether strap and the seating position has a top tether
anchorage, connect the tether strap to the anchorage and tighten the tether strap. See
the section "Installing Child Restraints Using the Top Tether Anchorage" for directions
to attach a tether anchor.
9. Test that the child restraint is installed tightly by pulling back and forth on the child
seat at the belt path. It should not move more than 1 inch (25.4 mm) in any direction.
Any seat belt system will loosen with time, so check the belt occasionally, and pull it tight
if necessary.
Installing Child Restraints Using The Top Tether Anchorage
Do not attach a tether strap for a rear-facing car seat to any location in front of the car
seat, including the seat frame or a tether anchorage. Only attach the tether strap of a
rear-facing car seat to the tether anchorage that is approved for that seating position,
located behind the top of the vehicle seat. See the section "Lower Anchors and Tethers
for CHildren (LATCH) Restraint System" for the location of approved tether anchorages
in your vehicle.
There is a tether strap anchor
passenger seat. To attach a child restraint tether strap to the anchor:
1. Move the seat forward.
2. Move the seatback to its full forward position.
G E T T I N G S T A R T E D
WARNING!
located behind the child tether access cover behind the
43