Removing The Drum Cleaning Blade - Canon imageRUNNER ADVANCE 6075 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Removing the Drum Cleaning Blade

Removing the Drum Cleaning Blade

<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
2. Remove the Primary Charging Assembly. (Refer to page 4-97)
3. Remove the Pre-transfer Charging Assembly. (Refer to page 4-108)
4. Remove the Process Unit. (Refer to page 4-114)
5. Remove the Drum Cleaning Unit. (Refer to page 4-118)
<Procedure>
1) Turn over the Drum Cleaning Unit to remove the Drum Cleaning Blade Unit.
• 1 E-ring
• 1 Plate
Drum Cleaning
Blade Unit
4 Parts Replacement and Clearning > Image Formation System > Removing the Drum Cleaning Blade
Plate
F-4-142
2) Remove the Drum Cleaning Blade.
• 5 Screws (to loosen)
Loosen
CAUTION:Points to Caution when Installing the Drum Cleaning Blade
Be sure to apply toner on the contact area (edge) on the Drum of the Drum Cleaning
Blade. In particular, be sure to apply toner on both edges of the Blade.
4-118
F-4-143
4-118