Operation Procedure Using Ping; Checking By The Remote Host Address; Network Troubleshooting; Checking Connection Of The Network Cable - Canon imageRUNNER ADVANCE 6075 Series Service Manual

■ Operation Procedure Using Ping

CAUTION:
To execute Ping command with the Windows Vista-installed PC, set OFF the firewall, or
execute Ping command from the Windows Vista-installed PC to the Host Machine.
1) Select the following: [Additional Functions] > [Configuration] > [Network] > [TCP/IP setting]
> [IPv4 setting] > [PING command]
2) Enter the IP address with the numeric keypad on the Control Panel and press "Execute"
key. "Response from the host" is displayed if Ping command is succeeded while "no
response from the host" is displayed if failed.

■ Checking by the Remote Host Address

Using the remote host address to execute Ping can check whether connection to the network
is enabled or not.
Remote host address: IP address of PC terminal connected/running on TCP/IP network
environment that connects to this equipment.
1) Inform the system administrator about checking of the network connection using Ping.
2) Confirm the remote host address with the system administrator.
3) Enter the remote host address to Ping.
• The network is properly connected if the message say "Response from the host".
• The network is not properly connected if the message say "No response from the host",
therefore, execute the following troubleshooting.
9
Installation > Installation > Network Troubleshooting > Operation Procedure Using Ping

Network Troubleshooting

■ Checking Connection of the Network Cable

To check whether the network cable is properly connected to the Ethernet Port.
■ Operation Procedure Using Ping
1) Ask the network administrator at the user's site to write down the IP address of the PC that
is connected to the network.
2) [Additional Functions] > [Configuration] > [Network] > [TCP/IP Setting] > [IPv4 setting] >
[Ping Command]; and enter the IP address of the PC with the numeric keypad and press
Execute key.
• The network is properly connected if the message say "Response from the host".
• If the message say "No response from the host", check the following.
NOTE:
The IP address of the PC can be checked by the following procedure:
Select the following on a Windows PC: Start > Program > Accessory > Command
Prompt; and enter "ipconfig" and press Enter key to display information of the IP
address.
9 Installation > Installation > Network Troubleshooting > Operation Procedure Using Ping
9-32
9-32