Table of Contents
Advertisement
Sterndrive Surface Care
c
e
f
g
We recommend the following maintenance items to help keep your sterndrive corrosion‑free:
•
Maintain a complete paint covering on the sterndrive.
•
Check the finish regularly. Prime and paint nicks and scratches using Mercury enamel paint and touch up paint. Use only
tin‑based antifouling paint or its equivalent on or near aluminum surfaces below the waterline.
•
If bare metal is showing, apply two coats of paint.
Description
Mercury Phantom Black
•
Spray all electrical connections with sealant.
Tube Ref No.
Liquid Neoprene
25
•
Inspect the sacrificial trim tab or anode plate if equipped, at regular intervals and replace it before it is half gone. If a
stainless steel propeller is installed, additional anodes or a MerCathode system will be required.
•
Inspect the propeller shaft for fishing line, which can cause corrosion on a stainless steel shaft.
•
Remove the propeller at least every 60 days and lubricate the propeller shaft.
•
Do not use lubricants containing graphite on or near the aluminum in saltwater.
•
Do not paint trim tabs or the mounting surface.
Lubrication
Steering System
Incorrect cable lubrication can cause hydraulic lock, leading to serious injury or death from loss of boat control. Completely
retract the end of the steering cable before applying lubricant.
NOTE: If the steering cable does not have a grease fitting, the inner wire of the cable cannot be greased.
90-8M0113987
DECEMBER 2015
eng
d
a
b
Description
Standard Bravo sterndrive
a -
Sacrificial trim cylinder anode
b -
Sacrificial anodic plate
c -
Steering lever ground wire
d -
Ground wire between the gimbal ring and bell housing
e -
Stainless steel hoses
f -
Ground wire between the gimbal housing and trim cylinder
g -
Ground wire between the gimbal ring and gimbal housing
21083
Where used
Bare metal
Where Used
All electrical connections
WARNING
!
Section 4 - Maintenance
Part number
92‑ 802878‑1
Part No.
92- 25711 3
Page 79
Advertisement
Chapters
Table of Contents
