Sony BDP-CX7000ES Service Manual page 5

ALIGNMENT OF GEAR (CAM) PHASE WITH DOOR ASSY
door assy
Align a slit of door assy with a marking on
the bottom land of gear tooth when the gear
is rotated fully in arrow direction, as shown.
MB-124-MEGA-EJ AND VP-062EJ BOARDS SERVICE POSITION
• It is necessary to connect MB-124-MEGA-EJ board (CN904) and IMD (ES) board (CN3005) with the extension cable to do the setting
to this position.
Prepare the following extension cables.
Part No. J-2501-068-A (19 pin, 1.00 mm pitch)
Connect jig (extension cable)
to the IMD board (CN3005)
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, for the electric shock prevention, con-
nect the resistors to both ends of respective capacitor (C106) to
discharge the capacitor (C106).
– Switching Regulator (Conductor Side) –
gear (cam)
CN904
800 /2 W
C106
MB-124-MEGA-EJ board
HARNESS SETTING ON SWITCHING REGULATOR
Note: This illustration sees the switching regulator from component side.
harness
clamp (L35)
AC inlet (2P) harness
BDP-CX7000ES
VP-062EJ board
insulation
wire
switching
regulator
5