Sony BDP-CX7000ES Service Manual page 28

BDP-CX7000ES
2. POP UP MECHANISM ADJUSTMENT
Procedure:
1. The case is detached. Step 1-3 is connected and the power cord
of the set is inserted.
2. Press the [ ] button, The message "TABLE_ADJUST *" is
N
appears on the fl uorescent indicator tube, and entering table
adjust mode. Table is locked (refer to Fig. 1).
3. The cover chassis is removed, and the screw is loosened (the
screw is not detached) (refer to Fig. 2).
4. The door is moved by the hand, and it puts it into the state that
there is no lever in the hole of the table.
5. The hole and the lever of the table are matched to the center (it
shines on with the spotlight etc. and confi rm it).
6. It is confi rmed that there is a lever in the position of the guide-
line under the table because it does not match it to the adjoin-
ing slot (refer to Fig. 3).
7. The door is moved by the hand, it is confi rmed that the lever
rises to the center of the hole of the table (refer to Fig. 4).
8. The screw of step 3 is fi xed (it is noted to tighten strongly and
not to destroy it), and the cover chassis is installed.
Cover (chassis 400)
Lever
(POP-UP 400)
28
At this position,this
part will be locked.
Fig. 1
Fix to the center so that the
lever (POP-UP 400) does
not touch the slit.
Fig. 2
Move the door
3. TABLE SENSOR ADJUSTMENT
Procedure:
1. The case is detached. Step 1-3 is connected and the power cord
of the set is inserted.
2. Press the [ ] button, The message "TABLE_ADJUST *" is
N
appears on the fl uorescent indicator tube, and entering table
adjust mode. Table is locked (refer to Fig. 5).
3. The message "TABLE HH: x T4: x" is appears on the fl uo-
rescent indicator tube.
4. The screw (PTTWH3X6) that is the fi xation of the holder (ta-
ble sensor 400) is loosened (the screw is not detached).
5. The holder is moved right and left (Fig. 6), and as for "x" of
"TABLE HH:", it always light, and "x" of "T4:" searches for
the position of the verge whether light (it is acceptable even if
it does not light if it is a verge).
6. The screw of step 4 is fi xed in the state of step 5.
7. It is confi rmed that the table is moved by the hand (move only
a little because it is locked), and "x" of "T4:" blinks.
Check
Fig. 3
Check
Fig. 4
At this position,this
part will be locked.
Fig. 5