Kyocera ECOSYS P8060cdn Operation Manual page 330

Troubleshooting > Troubleshooting
Symptom
Cannot print with USB
memory.
USB memory not
recognized.
While "Auto-IP" is already
set to [On], the IP
address is not assigned
automatically.
Cannot connect to this
machine by using Wi-Fi
Direct.
Cannot send via the
e-mail.
The machine is emitting
steam in the area around
the paper ejection slot.
Checkpoints
Is the USB host blocked?
―
Is a value other than "0.0.0.0"
entered for the link local address of
TCP/IP(v4)?
Are three handheld devices
connected simultaneously?
Is the E-mail send size limit set in
the SMTP server registered on the
machine?
Check the room temperature to see
if it is low, or if damp paper was
used.
Corrective Actions
Select [Unblock] in the USB host
settings.
Check that the USB memory is
securely plugged into the machine.
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
Release the connection of handheld
devices being connected manually
or set a connection after setting the
connection time and releasing the
connection by automatic
disconnection.
Check the limit value is entered to
"E-mail Size Limit" of [E-mail]
setting in Command Center RX and
change the value as necessary.
Depending on the printing
environment and the paper's
condition, the heat generated during
printing will cause the moisture in
the paper to evaporate, and the
steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam
concerns you, raise the room
temperature, or replace the paper
with a newer, dryer paper.
10-19
Reference
Page
page 8-46
―
page 2-25
page 8-31
page 2-55
―