Adjustment/Maintenance - Kyocera ECOSYS P8060cdn Operation Manual

Setup and Registration (System Menu) > System Menu

Adjustment/Maintenance

[System Menu/Counter] key > [Adjustment/Maintenance]
Adjust printing quality and conduct machine maintenance.
Item
Drum Refresh
Auto Drum Refresh
Drum Heater
Laser Scanner Cleaning
Developer Refresh
Open toner cover
System Initialization
Display Brightness
Silent Mode
Memory Diagnostics
Remove image blur and white dots from the printout. It takes about 1 to 2 minutes.
The time required may vary depending on the operating environment.
Drum Refresh (page 10-38)
NOTE
Drum Refresh cannot be performed while printing. Execute Drum Refresh after the
printing is done.
Select the time length of the drum refresh.
Value
Off: The Auto Drum Refresh will not be performed.
Short: Perform Auto Drum Refresh as Short.
Standard: Perform Auto Drum Refresh as Standard.
Long: Perform Auto Drum Refresh as Long.
Set the drum heater.
Value: Off, On
NOTE
This setting does not appear in some regions.
Remove vertical white lines from the printout.
Laser Scanner Cleaning (page 10-38)
Adjust the printed image that is too light or incomplete, even though there is enough
toner.
Developer Refresh (page 10-39)
NOTE
Waiting time may be longer when the toner is refilled during developer refresh.
Open the toner cover.
NOTE
This function is displayed when using a genuine toner container.
Initialize the hard disk/SSD installed on the machine to return it to the factory defaults.
NOTE
This function will not be displayed when the optional Data Security Kit is activated.
Set the brightness of the touch panel.
Value: 1 (Darker), 2, 3, 4, 5 (Lighter)
Set the Silent Mode. Select this mode when the running noise is uncomfortable.
Value: Off, On
NOTE
When [On] is selected, it may take time for the next print job to start.
Perform this function to check the machine memory.
8-53
Description