3.2.8 Wall Mounting
1.
Place the template (found on the last page of this manual) on the wall to mark the 2 screw positions.
A
Template
B
225 mm (8-7 / 8 in)
Note
When you print out the template, the distance on the paper output may deviate slightly from the indi-
cated measurement. In this case, use the indicated measurement.
2.
Install the screws and washers (included) to the wall.
C
Washer
Drive the screw to this point.
Note
•
As indicated above, do not tighten the screw fully.
•
The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
•
Do not block the operations of the cabinet. Allow space of at least 20 cm (8 in) above and 10 cm
(4 in) at the sides of the cabinet.
•
Make sure that screw heads are the same distance from the wall.
•
Install the screw perpendicular to the wall.
•
Be careful not to drop the cabinet.
54
B
A
C