Figure 4 Inserting Ventilator Into Unit - Bard CRVS-3 Installation Instructions Manual

IMPORTANT: Position front lip of ventilator
under front grille and on top of condenser
partition. (See Figure 4 inset.) This is important to
ensure proper drainage of any water entering
damper assembly.
FIGURE 4 INSET
SIDE SECTION
FIGURE 4
INSERTING VENTILATOR INTO THE UNIT
7. Open control panel to gain access to unit low
voltage terminal block.
8. Route electrical harness leads through the 7/8"
bushing in control panel (Figure 4) into low voltage
box.
Manual 2100-448E
Page 7 of 13