Table of Contents
Advertisement
5. Install ventilator sheet metal assembly by inserting
the ventilator into the unit to the far left side
clearing the right filter bracket. Once the ventilator
is fully inserted, slide the ventilator to the right
until it is tight against the back of the control panel.
(See Figure 3.)
IMPORTANT: Position front lip of ventilator on top of
front grille and condenser partition. (See Figure 3
inset.) This is important to ensure proper drainage
of any water entering damper assembly.
FIGURE 3 INSET
SIDE SECTION
Manual 2100-457D
Page
6 of 16
6. Open control panel to gain access to unit low
voltage terminal block.
7. Route electrical harness leads through the 7/8"
bushing in control panel (Figure 3) into low voltage
box.
FIGURE 3
INSTALL VENTILATOR
Advertisement
Table of Contents
