Replacing The Memory Module - Lenovo ideacentre All-In-One Y910 Hardware Maintenance Manual

Replacing the memory module

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the right rear cover. Refer to Removing the rear covers.
Step 5. Open the memory cover.
Step 6. Open the retaining clips
Step 7. To install the new memory module:
a. Position the new memory module over the memory slot. Ensure that the notch
memory module aligns correctly with the slot key
module straight down into the socket until the retaining clips close.
1
2 and gently pull the memory module out of the memory socket
2
3
1 in the memory socket. Push the memory
.
Chapter 8 Replacing hardware
3 .
1
2
2 on the
33