Replacing The Optical Drive - Lenovo ideacentre All-In-One Y910 Hardware Maintenance Manual

Step 5. Pull the hard disk drive and bracket to left
Step 6. Disconnect the signal cable from the hard disk drive.
Step 7. Remove the four screws that secure the hard disk drive to the bracket.
1
Step 8. To install the new hard disk drive:
a. Line up the new hard disk drive with the bracket and secure it with four screws.
b. Connect the data and power cables to the new hard disk drive.
c. Slide the hard disk drive and bracket back into position.
Step 9. Reattach the left rear cover.

Replacing the optical drive

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the left rear cover. Refer to Removing the rear covers.
Step 5. Remove the hard disk drive. Refer to Replacing the hard disk drive.
36
ideacentre All-In-One Y910 Computer Hardware Maintenance Manual
2
3
1 , and then lift them up.
3
3
3
2
3