After Finishing Work - Stihl MSA 120 C Instruction Manual

English
► With arms outstretched, cut through the holding strap from
outside at a downward angle.
The tree falls.
12.4.10 Felling a large diameter leaner
A leaner is felled with a felling cut and holding strap. This
felling cut must be performed if the tree diameter is greater
than the guide bar's length.
► Shout a warning.
1.
2. 3.
► Apply the spiked bumper behind the holding strap at the
same height as the felling cut and use it as a pivot.
► Hold the saw horizontally and swing it into the felling cut
as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at the same
height as the felling cut and use it as a pivot.
► Hold the saw horizontally and swing it into the felling cut
as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
30
► Shout a warning.
► With arms outstretched, cut through the holding strap from
outside at a downward angle.
The tree falls.
5. 6.
4.

13 After Finishing Work

13.1 After Finishing Work
► Switch off the chain saw, engage the chain brake and
remove the battery.
► If the saw is wet: Allow the saw to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the saw.
► Clean the bar and chain.
► Loosen the wingnut.
► Rotate the adjusting wheel two full turns
counterclockwise.
The chain is now slack.
► Tighten down the wingnut.
► Fit the scabbard so that it completely covers the guide bar.
► Clean the battery.
13 After Finishing Work
0458-716-0121-B