Related Manuals for Auto Page A.P.I. EXP-52
Summary of Contents for Auto Page A.P.I. EXP-52
- Page 1 EXP-52 OPERATION INSTRUCTIONS THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY!!
- Page 2 Congratulations on your purchase of the EXP-52 vehicle security system. Please take the time to read over this operation manual to thoroughly familiarize yourself with the many features and options. THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY!! !!NOTICE!! THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS...
- Page 3 EXP-52 OPERATION INSTRUCTIONS REMOTE CONTROL TRANSMITTER OPERATION The new remote control transmitter (XT-54) included with the EXP-52 offers the code rolling feature which will prevent illegal use of a code- grabber with an attempt to record the code of your transmitter.
-
Page 4: Panic Function
EXP-52 3. PANIC FUNCTION The EXP-52 remote control may be used as a remote panic switch to trigger the siren in cases of emergency. To activate the PANIC FUNCTION press and hold the ON/OFF button on the remote transmitter for a minimum of 3 seconds. The siren will sound. To stop the PANIC FUNCTION press the ON/OFF button on the transmitter. - Page 5 8. CHANGING THE REMOTE TRANSMITTER BATTERY The EXP-52 remote transmitter uses one (1) 12 volt miniature battery, #EL12, #VR22, or Radio Shack #23-144. It will provide approximately one year of operation before replacement is necessary.
-
Page 6: Override Function
LED will be flashing in a 2 second flash/hold sequence. VALET/OVERRIDE SWITCH NOTE: Both VALET and OVERRIDE functions are performed from the same switch. 1. OVERRIDE FUNCTION The OVERRIDE FUNCTION may be used if the EXP-52 remote is lost or inoperative. To operate the OVERRIDE FUNCTION, enter the vehicle... -
Page 7: Passive Arming
2. VALET FUNCTION The EXP-52 may be placed into the VALET (stand-by) mode to allow for vehicle service, car washing, or attendant parking without self arming after the ignition is switched off, and without leaving the EXP-52 remote control with unauthorized individuals. -
Page 8: Automatic Rearming
If you choose the MANUAL (active) arming mode, follow the steps below. 1. Switch off ignition, leave vehicle, and close all protected openings. 2. Press the ON/OFF button on the remote transmitter. 3. The siren will chirp 1 time. 5 seconds later the EXP-52 will be fully armed. AUTOMATIC RE-ARMING... -
Page 9: Trigger Test
3. If optional sensors have been installed, arm the EXP-52 and test according to the directions of the particular sensor installed. If triggered in the armed condition, the EXP-52 will sound its siren and flash the lights for 60 seconds; then it will stop and automatically reset and rearm. - Page 10 The second transmitter is now programmed. NOTE: If the EXP-52 does not receive a second code to learn within five (5) seconds, it will automatically close the programming mode and resume normal alarm functions. If this happens, it will be necessary to repeat steps 1 through 6 and re-program all transmitters.
- Page 11 To code the EXP-52 transmitters for two or three vehicles follow the diagrams as shown below. Before multiple vehicle programming can be achieved, it is necessary to enter the programming mode as described in SECTION K. 1. TWO VEHICLE OPERATION...
- Page 12 A.P.I.