Professional 915 mhz. 2-way lcd remote car starter & alarm system with built in temperature sensor and two-way serial port data link (28 pages)
Summary of Contents for Auto Page RF-425LCD
Page 1
RF-425LCD PROFESSIONAL VEHICLE SECURITY SYSTEM INSTALLATION MANUAL (FOR AUTHORIZED DEALERS ONLY) THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY...
WIRING Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape wires that pass through holes on the firewall to prevent fraying. Be careful of sharp edges that may damage wires and causes short circuit. CAUTION: Do not connect the wire harness to the control module until all wiring to vehicle is complete.
10-PIN MINI CONNECTOR WIRE HARNESS. 1. BLUE WIRE -- GROUND INSTANT TRIGGER INPUT -- This wire is the ground trigger input wire for hood/trunk pin switches. 2. Black / BLUE WIRE – (-) 200mA Timer Control Channel 4 Output – This wire has a built-in user-programmable timer output that provides a ground through this wire.
8. WHITE/BLUE WIRE – PROGRAMMABLE OUTPUT – CHANNEL 3 OUTPUT (Factory default setting) This wire is built-in user-programmable timer output provides a ground through this wire. Press the button on the transmitter. You may program the built-in timer to send a ground signal for any time interval between 1 second and 2 minutes.
6 PIN DOOR LOCK CONNECTOR: 3-WIRE NEGATIVE BROWN UNLOCK SWITCH... N/C (87a) NOT USED LT. BLUE UNLOCK MOTOR... COMMON (30) VIOLET UNLOCK... N/O (87) WHITE LOCK SWITCH...N/C (87a) NOT USED LT. GREEN LOCK MOTOR... COMMON (30) VIOLET/RED LOCK... N/O (87) LOCK LOCK GROUND...
Page 8
5-WIRE REVERSE POLARITY BROWN UNLOCK SWITCH... N/C (87a) LT. BLUE UNLOCK MOTOR... COMMON (30) VIOLET UNLOCK... N/O (87) WHITE LOCK SWITCH...N/C (87a) LT. GREEN LOCK MOTOR... COMMON (30) VIOLET/RED LOCK... N/O (87) 12+ VOLTS LOCK LOCK ADDING ACTUATORS WHITE WIRE GROUND &...
VACCUM DOOR LOCK SYSTEM BROWN WIRE LOCK BLUE WIRE LOCK VIOLET WIRE (12v B+) 405 6-PIN CONNECTOR WHITE WIRE BROWN FROM DOOR GREEN WIRE VIOLET / RED WIRE (GROUND) GREEN WIRE TO PUMP LOCK PUMP PROGRAMMING A. TRANSMITTER PROGRAMMING Enter: 1.
ALARM FEATURE “A” PRORAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2. Push the Valet switch 3 times and hold in on the 3rd push, when a long chirp is heard then release the valet switch. You are now in the Alarm feature ‘A’ programming mode. 3.
ALARM FEATURE “C” PRORAMMING: 1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2 Push the Valet switch 7 times and hold in on the 7 push, when a long chirp is heard, then release the valet switch. You are now in the Alarm feature ‘C’ programming mode. 3 Press the transmitter button corresponding to the feature you want to program.
Page 12
960 Knox Street, Unit B Torrance, California 90502 Main Office: 310-323-1800 Technical Support: 800-262-2527 Ext. 461 (For Authorized Dealers Only) www.autopageusa.com...