Juniper EX9200 Features Manual page 41

Copyright © 2016, Juniper Networks, Inc.
Specify packet-selection properties:
3.
Specify the number of packets to select:
a.
[edit forwarding-options port-mirroring instance pm-instance-name input]
user@host# set rate number
The valid range is through
1
Specify the number of packets to mirror from each selection:
b.
[edit forwarding-options port-mirroring instance pm-named-instance input]
user@host# set run-length number
The valid range is 0
NOTE: The
Specify the length to which mirrored packets are to be truncated:
c.
[edit forwarding-options port-mirroring instance pm-instance-name input]
user@host# set maximum-packet-length number
The valid range is through
0
packets are not truncated.
NOTE: The
MX80 routers.
Enable configuration of the mirror destination properties for Layer 2 packets that are
4.
part of bridging domain, Layer 2 switching cross-connects, or virtual private LAN service
(VPLS):
Specify the Layer 2 address family type of traffic to be mirrored:
a.
[edit forwarding-options port-mirroring instance pm-instance-name input]
user@host# up
[edit forwarding-options port-mirroring instance pm-instance-name]
user@host# edit family family
The value of the family option can be
NOTE: Under the
level, the protocol family statement
for
family vpls
port-mirroring configurations as
port-mirroring configured as
ethernet-switching
encapsulation ethernet-bridge
Enable configuration of the mirror destination properties:
.
65535
through 20 . The default value is
statement is not supported on MX80 routers.
run-length
. The default value is
9216
maximum-packet-length
ethernet-switching
[edit forwarding-options port-mirroring]
. The command-line interface (CLI) displays Layer 2
family vpls
family ethernet-switching
when the physical interface is configured with
.
Chapter 5: Port Mirroring Instances
0 .
, which means the mirrored
0
statement is not supported on
, , or .
ccc vpls
hierarchy
is an alias
family ethernet-switching
, even for Layer 2
. Use
family
25