To Accelerate For Passing; To Resume Speed; To Deactivate; Parking Sensors - If Equipped - Alfa Romeo 4C User Manual

Hide thumbs Also See for 4C:
Table of Contents

Advertisement

To Accelerate For Passing

Press the accelerator as you would normally.When
the pedal is released, the vehicle will return to the
set speed.

To Resume Speed

To resume a previously set speed, push the RE-
SUME button, located on the end of the speed
control stalk, and release. Resume can be used at
any speed above 18 mph (30 km/h).

To Deactivate

A soft tap on the brake pedal, pushing the
CANCEL/RESUME button on the end of the stalk,
or normal brake pressure while slowing the vehicle
will deactivate the Speed Control without erasing
the set speed memory. Rotating the end of the
multifunction lever to the O (off) position, or turn-
ing the ignition switch to OFF, erases the set speed
memory.
PARKING SENSORS — IF
EQUIPPED
Your vehicle may be equipped with Parking Sen-
sors. The four Parking Sensors are located in the
rear bumper and their function is to detect the
78
presence of any obstacles near the rear part of the
vehicle; they consequently inform the driver,
through an intermittent acoustic signal.
The sensors are automatically activated when RE-
VERSE gear is engaged and a visual display will
appear in the instrument cluster display. As the
obstacle behind the vehicle gets closer, the
acoustic signal becomes more frequent.
WARNING!
Drivers must be careful when backing up even
when using the Parking Sensor system. Always
check carefully behind your vehicle, and be
sure to check for pedestrians, animals, other
vehicles, obstructions, or blind spots before
backing up. You are responsible for the safety
of your surroundings and must continue to pay
attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
• The Parking Sensor system is only a parking
aid and it is unable to recognize every ob-
stacle, including small obstacles. Parking
CAUTION!
curbs might be temporarily detected or not
detected at all. Obstacles located above or
below the sensors will not be detected when
they are in close proximity.
• The vehicle must be driven slowly when using
the Parking Sensor system in order to be
able to stop in time when an obstacle is
detected. It is recommended that the driver
looks over his/her shoulder when using the
Parking Sensor system.

ADDING FUEL/SMART FUEL

NOTE:
The "Smart Fuel" is a device placed on the top of
the filler pipe; it opens and closes automatically
when the fuel nozzle is inserted or extracted.
Only the correct nozzle size diameter allows the
flap door to open when the nozzle is inserted.
Refueling Procedure
1. Open the fuel filler door pulling towards
outside.

Advertisement

Table of Contents
loading

This manual is also suitable for:

4c20184c spider

Table of Contents