Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface; Enabling Link State Traps For An Aggregate Interface - HP 5120 EI Series Lan Switching Configuration Manual

Configuring an aggregate interface

Most of the configurations that can be performed on Layer 2 Ethernet interfaces can also be performed
on Layer 2 interfaces.

Configuring the description of an aggregate interface

You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface:
Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Configure the description
of the aggregate interface.

Enabling link state traps for an aggregate interface

You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see Network Management and
Monitoring Configuration Guide.
To enable link state traps on an aggregate interface:
Step
1. Enter system view.
2. Enable the trap function
globally.
Command
system-view
interface bridge-aggregation
interface-number
description text
Command
system-view
snmp-agent trap enable [ standard
[ linkdown | linkup ] * ]
43
Remarks
N/A
N/A
Optional
By default, the description of an
interface is in the format of
interface-name Interface, such as
Bridge-Aggregation1 Interface.
Remarks
N/A
Optional
By default, link state trapping is
enabled globally and on all
interfaces.