Enabling MVRP on a Layer 2 aggregate interface enables both the aggregate interface and all
•
Selected member ports in the link aggregation group to participate in dynamic VLAN registration
and deregistration.
Configuration procedure
To enable MVRP:
Step
1.
Enter system view.
2.
Enable MVRP globally.
3.
Enter interface view.
4.
Configure the port to permit
the specified VLANs.
5.
Enable MVRP on the port.
Configuring the MVRP registration mode
Step
1.
Enter system view.
2.
Enter interface view.
Command
system-view
mvrp global enable
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
port trunk permit vlan { vlan-list |
all }
mvrp enable
Command
system-view
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
208
Remarks
N/A
By default, MVRP is globally
disabled.
To enable MVRP on a port, first
enable MVRP globally.
Use one of the commands.
By default, a trunk port permits only
VLAN 1.
Make sure that the trunk port
permits all registered VLANs.
For more information about the
port trunk permit vlan command,
see Layer 2
LAN Switching
—
Command Reference.
By default, MVRP is disabled on a
port.
Remarks
N/A
Use one of the commands.