Enabling Gvrp Compatibility; Configuration Restrictions And Guidelines; Configuration Procedure; Displaying And Maintaining Mvrp - HP 5120 EI Series Lan Switching Configuration Manual

Table 28 Dependencies of the Join, Leave, and LeaveAll timers
Timer
Join
Leave
LeaveAll
NOTE:
You can restore the Periodic timer to the default at any time.

Enabling GVRP compatibility

MVRP can be compatible with GVRP. When the peer device supports GVRP, you can enable GVRP
compatibility on the local end, so that the local end can receive and send MVRP and GVRP protocol
packets at the same time.

Configuration restrictions and guidelines

MVRP with GVRP compatibility enabled can work together with STP or RSTP, but cannot work
•
together with MSTP. When MVRP with GVRP compatibility enabled works with MSTP, the network
might operate improperly.
When GVRP compatibility is enabled for MVRP, HP recommends disabling the Period timer.
•
Otherwise, the VLAN status might frequently change when the system is busy.

Configuration procedure

To enable GVRP compatibility:
Step
1. Enter system view
2. Enable GVRP
compatibility

Displaying and maintaining MVRP

Task
Display the MVRP status of
the specified port and each
MVRP interface in the
specified VLAN.
Display the MVRP running
status.
Lower limit
20 centiseconds
Twice the Join timer
Leave timer on each port
Command
system-view
mvrp gvrp-compliance
enable
Command
display mvrp state interface interface-type
interface-number vlan vlan-id [ | { begin |
exclude | include } regular-expression ]
display mvrp running-status [ interface
interface-list ] [ | { begin | exclude |
include } regular-expression ]
210
Upper limit
Half the Leave timer
LeaveAll timer
32760 centiseconds
Remarks
N/A
By default, GVRP compatibility is disabled.
Remarks
Available in any view
Available in any view