Oil And Oil Filter Change - Triumph Street Twin Owner's Handbook Manual

When correct, oil should be visible in the
sight glass at a point midway between
the upper (maximum)
(minimum) markings on the sight glass.
Note:
• An accurate indication of the level
of oil in the engine is only shown
when the engine is at normal
operating temperature
motorcycle is upright (not on the
side stand).
If it is necessary to top up the oil level,
remove the filler plug and add oil, a little
at a time, until the level registered in
the sight glass is correct.
Caution
Make sure no foreign matter or
contamination
during an oil change or top up.
Contamination entering the engine
may lead to engine damage.
Once the correct level is reached, fit and
tighten the filler plug.
and lower
and
enters the engine
Maintenance And Adjustment

Oil and Oil Filter Change

Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis. In addition,
used engine
contamination that can lead to skin
the
cancer.
protective clothing and avoid skin
contact with used oil.
The oil may be hot to the touch. Avoid
contact with the hot oil by wearing
suitable protective clothing, gloves, eye
protection, etc. Contact with hot oil may
cause the skin to be scalded or burned.
If the engine
running, the exhaust system will be
hot. Before working on or near the
exhaust system, allow sufficient time
for the exhaust system to cool as
touching any part of a hot exhaust
system could cause burn injuries.
The engine oil and filter must be
renewed in accordance with scheduled
maintenance requirements.
To change the engine oil and filter,
follow the instructions.
Warm up the engine thoroughly then
stop the engine. Secure the motorcycle
on the side stand.
Allow the oil to settle for five minutes
before draining.
Warning
oil contains
Always wear
Warning
Warning
has recently
harmful
suitable
been
91