Put The Media Through The Rear Roller Assembly - MUTOH VJ-1938TX Operation Manual

[7]

Put the media through the Rear roller Assembly

[1]
NORMAL
[2]
[3]
40

Put the media through the Rear roller Assembly

v u
w
A
A
A
A
Loosen the screws with a handle on left and right sides, and then adjust the
position of the roll media.
• Make sure that the center of the roll media and the center of the media feed
slot are aligned.
• Once adjustment is complete, tighten and secure the screw with a handle.
Move the MANUAL switch on the rear tension unit to the NORMAL side and
pull the roll media out about 1.5 m.
Put the roll media over the rear roller (A).
• For the outside roll media, see the left illustration.
• For the inside roll media, see the left illustration.
Put the roll media from the bottom to the top over the rear tension unit's
tension roller.