Checking The Configuration; Configuring Link Aggregation In Static Lacp Mode; Establishing The Configuration Task - Huawei Quidway S7700 Configuration Manual - Ethernet

Smart routing switch

Hide thumbs Also See for Quidway S7700:

Table of Contents

Quidway S7700 Smart Routing Switch

Configuration Guide - Ethernet

The load balancing mode for unknown unicast traffic is configured.

2.3.8 Checking the Configuration

This section describes how to configure link aggregation in static LACP mode.

Applicable Environment

To increase the bandwidth and improve the connection reliability, you can configure a link

aggregation group on two directly connected Switches. The requirements are as follows:

Figure 2-3 Typical networking of link aggregation in static LACP mode

Pre-configuration Tasks

Before configuring an Eth-Trunk in static LACP mode, complete the following tasks:

Data Preparation

To configure an Eth-Trunk in static LACP mode, you need the following data.

Issue 01 (2011-07-15)

Run the display trunkmembership eth-trunk trunk-id command to display the member

interfaces of the Eth-Trunk.

Run the display eth-trunk trunk-id command to display the load balancing status of the

The links between two devices can implement redundancy backup. When a fault occurs on

some links, the backup links replace the faulty ones to keep data transmission uninterrupted.

The active links have the load balancing capability.

Powering on the S7700

Creating the Eth-Trunk

Huawei Proprietary and Confidential

2 Link Aggregation Configuration

Standby link

Quidway s9300