Monitoring The Operation Status Of The Link Aggregation Group; Configuration Examples; Example For Configuring Link Aggregation In Manual Load Balancing Mode - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
l
l
l
----End
2.7.3 Monitoring the Operation Status of the Link Aggregation
Group
Context
During the daily maintenance, you can run the following commands in any view to check the
operation status of the link aggregation group.
Procedure
l
l
l
----End

2.8 Configuration Examples

This section provides several configuration examples of link aggregation in manual load
balancing mode and in static LACP mode.
2.8.1 Example for Configuring Link Aggregation in Manual Load
Balancing Mode
Networking Requirements
As shown in
link between the Switch and SwitchA must ensure high reliability, and data traffic needs to be
load balanced among the LPUs of the Switch. To meet this requirement, you need to configure
an inter-board Eth-Trunk on the Switch.
Issue 01 (2011-07-15)
Run the debugging trunk state-machine command to enable the debugging of Eth-Trunk
status machine.
Run the debugging trunk updown command to enable the debugging of Eth-Trunk Up
and Down messages.
Run the debugging trunk command to enable the debugging of Eth-Trunk messages.
Run the display eth-trunk [ trunk-id [ interface interface-type interface-number ] ]
command to display the status of the link aggregation group.
Run the display lacp statistics eth-trunk [ trunk-id [ interface interface-type interface-
number ] ] command to display the statistics of sent and received LACP packets.
Run the display trunkmembership eth-trunk trunk-id command to display the member
interfaces of the Eth-Trunk.
Figure 2-5, the Switch is connected to the SwitchA through an Eth-Trunk. The
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
46