Maintaining Link Aggregation; Clearing Statistics Of Lacp Packets; Debugging The Link Aggregation Group - Huawei Quidway S7700 Configuration Manual - Ethernet

Smart routing switch

Hide thumbs Also See for Quidway S7700:

Table of Contents

Quidway S7700 Smart Routing Switch

Configuration Guide - Ethernet

2.7 Maintaining Link Aggregation

This section describes how to clear the statistics of received and sent LACP packets, debug the

link aggregation group, and monitor the running status of the link aggregation group.

The statistics of LACP packets cannot be restored after you clear them. So, confirm the action

before you use the command.

Debugging affects the performance of the system. So, after debugging, run the undo debugging

all command to disable it immediately.

When a running fault occurs in the link aggregation group, run the following debugging

commands in the user view to check the debugging information, and locate and analyze the fault.

Issue 01 (2011-07-15)

Run the reset lacp statistics eth-trunk [ trunk-id ] command to clear statistics of received

and sent LACP packets.

Run the debugging trunk error command to enable the debugging of Eth-Trunk errors.

Run the debugging trunk event command to enable the debugging of Eth-Trunk events.

Run the debugging trunk lacp-pdu command to enable the debugging of LACP packets.

Run the debugging trunk lagmsg command to enable the debugging of LACP protocol

Run the debugging trunk msg command to enable the debugging of Eth-Trunk messages.

Huawei Proprietary and Confidential

2 Link Aggregation Configuration

Quidway s9300