Configuring The Eth-Trunk To Work In Static Lacp Mode; Adding Member Interfaces To An Eth-Trunk - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
No.
1
2
3

2.4.2 Configuring the Eth-Trunk to Work in Static LACP Mode

Context
Do as follows on the S7700 where you need to configure an Eth-Trunk of static LACP mode.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk view is displayed.
Step 3 Run:
mode lacp-static
The Eth-Trunk is configured to work in static LACP mode.
By default, an Eth-Trunk works in manual load balancing mode.
If the local device is configured with an Eth-Trunk of static LACP mode, you must configure
the Eth-Trunk of static LACP mode on the peer device.
----End

2.4.3 Adding Member Interfaces to an Eth-Trunk

Context
Do as follows on the S7700 where you need to configure member interfaces of an Eth-Trunk.
Issue 01 (2011-07-15)
Data
Number of the Eth-Trunk
Type and number of the member interface
Maximum number of active interfaces
NOTE
Check whether the Eth-Trunk contains member interfaces before you configure the operation mode of the
Eth-Trunk. If the Eth-Trunk contains member interfaces, the operation mode of the Eth-Trunk cannot be
changed. To delete member interfaces from the Eth-Trunk, run the undo eth-trunk trunk-id command in
the interface view or run the undo trunkport interface-type interface-number command in the Eth-Trunk
view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
27