Optional) Setting The Lacp Priority Of The System; Optional) Setting The Lacp Priority Of An Interface - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
----End

2.4.6 (Optional) Setting the LACP Priority of the System

Context
Do as follows on the S7700 where you need to set the LACP priority of the system.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
lacp priority priority
The system LACP priority of the S7700 is set.
The smaller the LACP priority value of the system is, the higher the priority is. By default, the
LACP priority of the system is 32768.
The end of a smaller priority value functions as the Actor. If the two ends have the same priority,
the end with a smaller MAC address functions as the Actor.
----End

2.4.7 (Optional) Setting the LACP Priority of an Interface

Context
Perform the following steps on the S7700.
Issue 01 (2011-07-15)
The Eth-Trunk view is displayed.
3. Run:
least active-linknumber link-number
The lower threshold of the number of active interfaces is set.
By default, the lower threshold of the number of active interfaces is 1.
In static LACP mode, you can determine the minimum number of active interfaces in the
Eth-Trunk by setting the lower threshold. If the number of active interfaces is smaller than
the value in static mode, the status of the Eth-Trunk becomes Down.
NOTE
l The lower threshold of the number of active interfaces should not be larger than the upper
threshold of the number of active interfaces.
l The lower threshold of the number of active interfaces of the local S7700 and that of the remote
S7700 can be different. If the lower thresholds at two ends are different, the larger one is used.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
31