Scanning Only The Specified Memory Channels; Programmable Memory Channel Scan (Pms); Registering To The Programmable Memory Channels; Performing Programmable Memory Channel Scan - Yaesu FT-70DR Advance Manual

Scanning Only the Specified Memory Channels

1. Recall the memory channel registered as a specified memory channel.
2. Press the [ F ] key, then press the [ 2 ] (SCAN) key to start scanning.
Only the memory channels registered as the specified memory channels are
scanned.
Unless two or more specified memory channels are registered, the specified memory channel
scanning does not function.

Programmable Memory Channel Scan (PMS)

Registering to the Programmable Memory Channels

50 sets of PMS memory channels (L1/U1 to L50/U50) are available.
Register the lower and upper frequencies of the frequency range in a pair of Program-
mable Memory Channels,
L££: Lower limit memory channel
U££: Upper limit memory channel
For more details on registering frequencies to the memory channel, see "Registering To
Memory channel" (see the operating manual).
z Make sure to use the corresponding numbers for the lower and upper limit memory channels.
z Set the PMS memory channel for performing the Programmable Memory scanning (PMS) as
follows.
• The scan width of the upper and lower limit frequencies must be 100 kHz or more.
• The lower and upper limit memory channels must be within the same frequency band.
• The lower and upper limit memory channels must not register the lower and upper
channels in reverse.
• The PMS memory channel must not register a skip memory channel.

Performing Programmable Memory Channel Scan

The programmable memory channel scan allows scanning a specified frequency range
within the same frequency band.
1. Recall the PMS memory channel to which the lower limit (L££) or upper limit (U££)
of the frequency is registered.
2. Press the [ F ] key, then press the [ 2 ] (SCAN) key.
Programmable memory channel scanning starts.
• During scanning, "P££" appears on the upper left side of the LCD.
• If the DIAL knob is rotated while scanning is in progress, the scanning will contin-
ue up or down in frequency according to the direction of the DIAL Knob rotation.
If the scanner halts on an incoming signal, the back light will turn ON and the dec-
imal point between the "MHz" and "kHz" digits of the frequency display will blink.
Scanning will resume in about five seconds.
3. Press the PTT switch to cancel the scanning.
z If the scan has paused on a signal, rotating the DIAL knob will cause scanning to resume
instantly.
z During scanning, the frequency may be changed only within the programmed frequency
range.
z During scanning, press the [ V/M ] key to return to the normal memory mode.
18
FT-70DR/DE Advance Manual