Configuring Mac Traffic Classes - Cisco WAP125 Administrator's Manual

Access Control
• Destination Port — Includes a destination port in the match condition for the rule. The destination port is identified
in the datagram header.
◦Any — Any port is allowed as the destination port.
◦Select From List — Matches a keyword associated with the source port: ftp, ftpdata, http, smtp, snmp, telnet,
tftp, www. Each of these keywords translates into its equivalent port number.
◦Custom — Matches the source port number in the datagram header to an IANA port number that you specify.
The port range is from 0 to 65535 and includes three different types of ports:
◦0 to 1023 — Well-Known Ports
◦1024 to 49151 — Registered Ports
◦49152 to 65535 — Dynamic and/or Private Port
• IPv6 Flow Label — The Flow Label is used by a node to label packets in a flow.
◦Any — Any 20-bit number that is unique to an IPv6 packet.
◦User Defined — Enter a 20-bit number that is unique to an IPv6 packet. It is used by end stations to signify
QoS handling in routers (range 0 to FFFFF).
• Service Type — Specifies the type of service to use in matching the packets to the class criteria.
◦Any — Allows for any type of service as a match criterion.
◦IP DSCP Select from List — Choose a DSCP value to use as a match criterion.
◦IP DSCP Match to Value — Enter a custom DSCP value from 0 to 63
Step 7 Click OK. The changes are saved to the Startup Configuration.
Note To delete or modify a class map, select the Class Map Name from the list and click Delete. The class map cannot
be deleted if it is already attached to a policy.
Step 8 Click Save.

Configuring MAC Traffic Classes

To add and configure a MAC class map:
Step 1 Select Client QoS > Traffic Classes.
Step 2
Click ✚ to add a Traffic Class.
Note The maximum number of class maps is
50.
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
Configuring MAC Traffic Classes
77