Assembly Of The Safety Guard - Shindaiwa T2510 Operator's Manual

Assembly of the Safety Guard

Install the Safety Guard
Bolt
Upper
Clamp
Spacer
Bolt
Lower Clamp
Figure 6
1. Insert the safety guard between
the outer tube and the lower clamp.
See Figure 6.
2. Fit the two spacers and the upper
clamp over the outer tube and
loosely install the four bolts.
See Figure 6.
NOTE:
It may be necessary to loosen the nut
and bolt to adjust lower clamp.
CAUTION!
Make sure the clamp screw and
nut is securely tightened before
tightening the four bolts.
WARNING!
NEVER operate the T2510 and
C2510 without the Safety Guard
installed and tightly secured!
Outer
Tube
Safety Guard
Spacer
Install the Sub Guard
Safety Guard
Figure 6A
1. Install the sub guard.
See Figure 6A.
NOTE:
Make sure the edge of Safety Guard
is aligned with the groove of the sub
guard.
CAUTION!
Make sure the sub guard is
completely hooked at the hook
receiver.
WARNING!
NEVER use this machine
without sub guard when using a
trimmer head.
Hook Receiver
Hook
Sub Guard
9