Installation Of The Trimmer Head - Shindaiwa T2510 Operator's Manual

WARNING!
Before operating, make sure
the blade is securely mounted.
Turn the blade with your hand
slightly and make sure the
blade turns smoothly without
wobbling.
Make sure the direction of the
arrow indicated on the blade
corresponds with the arrow
indicated on the safety guard.
Hex Wrench
Plug Wrench
Figure 13
Installation of the
Trimmer Head
The bolt, bolt guard, and safety clip
are not used with a trimmer head
cutting attachment. Save these parts
for future blade installation.
1. Make sure the switch is turned off
2. Turn the unit over so the gearshaft
3. Remove the bolt, bolt guard,
4. Attach holder onto the gear shaft.
Hex Wrench
5. Rotate Holder A until the hole
CAUTION!
Never use this machine without
sub guard when using a trimmer
head.
IMPORTANT!
and the engine is stopped.
from the gearcase faces up.
holder and the safety clip from the
output shaft.
Gearshaft
Figure 14
in Holder A aligns with the hole
in the gearcase. Using the hex
wrench, lock the gearcase as
shown.
Holder
Holder A
13