Blade And Trimmer Head - Shindaiwa T2510 Operator's Manual

Blade and Trimmer Head

Recommended Blades
WARNING
Non-standard parts may not
operate properly with your unit
and may cause damage and lead
to personal injury.
Make sure to use the following
recommended Shindaiwa blades with
this machine.
Part Number: 60903-98310
8-Tooth Blade
Inner Bore: 25.4 mm
Diameter: 255.0 mm
Thickness: 2.0 mm
Figure 35
Part Number: 60903-98320
4-Tooth Blade
Inner Bore: 25.4 mm
Diameter: 255.0 mm
Thickness: 2.0 mm
Figure 36
Recommended
Trimmer Head
Part Number: 67000-65010
Type: Automatic
Cutting Line: Nylon
Line Diameter: 2.0 mm
Figure 37
32
Blade Sharpening
With a file or a grinder, file a blade as
follows.
WARNING!
Sharpen only the cutting teeth
of a blade. DO NOT alter the
contour of the blade in any way.
In order to keep the blade in
balance, all cutting edges must be
sharpened equally.
DO NOT file the tips of the teeth
too sharp.
IMPORTANT!
The sharpening angle should be
approximately 45°.
Do not file the tips of the blade
too sharp. Leave 0.2-0.5 mm
unsharpened.
0.2 - 0.5mm
Figure 38
The bottom of each tooth must
remain unsharpened.
Figure 39
45°