Appendix A Jumper Settings - Panasonic KX-PNBC8 User Manual

Appendix A
Jumper Settings
The Network Card will normally automatically configure the network configuration
without the need to access internal jumpers. However, there are certain jumpers on
the board that you may have to access under certain circumstances. If you need to
change the jumpers, follow the steps in this section.
The Network Card is normally contained within the printer which acts to protect sensitive
components from damage due to electrostatic discharge (ESD) during normal operation.
When performing installation procedures, however, take proper static control precautions
to prevent damage to equipment.
Make sure you do not have the printer plugged into a wall outlet. If it is, unplug the
power cord Before you open the unit. Remove the Network Card according to the
printer instructions.
136
HANDLING PRECAUTIONS
FOR
STATIC SENSITIVE DEVICES