Whitfield Profile 20 FS Installation And Operation Manual page 32

SPECIFICATIONS
- Profile 30 FS
Approx. Sq. Ft Heat
Capacity
Flue Size
Width, Overall
Depth, Overall
Depth, Overall w / 3" tee
Height
Floor to Rear
Flue Center
Facing Back of Unit,
outside edge on right
to center of rear
flue outlet
Floor to Rear
Outside Air Inlet
Facing Back of Unit
outside edge on right
to center of air inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Burn time
Fuse, Control Board
Fuse, Igniter
Heat Input (Max.)
Overall Efficiency
Emissions
Ship Weight
Room Fan
Auger Motor
Draft Fan
Options
~1800 - 2000 sq. Ft.
3" Rear
25 7/8"
24 7/8"
30 3/4"
31 3/8"
16 7/8"
5 1/8"
10"
12 1/2"
+ Front and Side: 6"
Back: 1"
Fastfire Self Igniter
Wall Thermostat
(wire included)
80 lbs.
♦ 18-48 hours
5 Amp, 250 volt, 3AG *
6 Amp, 125 volt *
♦ 14,000-39,000 BTU / hr
81%
♦ 1.9 gr / hr (varies w / size
and type of fuel) EPA ex-
empt
270 lbs.
150 CFM; .8 Amps,
2175 rpm
1 RPM; .4 Amps
95 CFM: 1.0 Amps,
2880 rpm
Nickel or Gold Trim Kits
4" Quick Disconnect
Log Set
Note: Dimensions shown are approximations only (+/- ¼")
~ Square footage heating capacities are approximations
only. They will vary depending upon the level of insu-
lation, climate, house design, ceiling height, ambient
outside temperatures and how the stove is operated.
+ Non-combustible floor protection must be used when
installed on carpet (see Floor Protection, page 5).
♦ ♦ ♦ ♦ Fuel delivery and burn times will vary depending
on size and type of fuel used. Estimated heat input
based on fuel value of 8500 BTU per lb.
* Fuses are rated as fast blow.
PAGE 32
BACK VIEW
SIDE VIEW