Whitfield Profile 20 FS Installation And Operation Manual page 30

ANNUAL MAINTENANCE
Unplug and Ensure Stove is Cold Before Performing Any Maintenance Work. Include routine maintenance with an-
nual maintenance. The following areas need to be inspected and cleaned as part of annual maintenance:
Sweep Away Debris from Behind Window Wash Bracket
•
(Recommended Frequency of 1 year)
SMALL AREA PAINT TOUCH-UP
The stove body is painted with a quality high-temperature
stove paint. Use only model TSPK-B Stove Paint, Catalog
# 70K99. Do not touch-up your stove with any other paint.
Using one small piece of 320 grit sand paper and lightly sand
the blemish so that the edges are "feathered" or smooth to the
touch between the painted and bare surfaces. Do not let the
sand paper gum up with paint, as this will cause scratches on
the metal surface. If there are any scratches, use 600 grit
sandpaper instead. Mask off surfaces you do not want painted.
Paint lightly over the bare surface first as this will act as an un-
dercoat. Then paint over a larger area in smooth even strokes
to blend.
REAR STOVE COMPARTMENT (All Models)
The rear stove compartment should be cleaned periodi-
cally (a minimum of once a year). DISCONNECT ELEC-
TRICAL CORD PRIOR TO CLEANING STOVE. Any
household dust, pet hair or sawdust should be vacuumed
or wiped out of the rear compartment of the stove, room
air blower, and combustion blower (paying special atten-
tion to vacuuming out the intakes of both blowers). The
electrical components should be wiped clean.
Opening Side Panels
Profile 30 FS - Using a 5/16" nut driver remove the screw
from underneath the side panel at the front edge. Rein-
stall screw to prevent panel from opening accidentally!
* Inspect at minimum frequency stated until you establish a minimum frequency required for your installation (frequency
will vary depending upon fuel BTU value / ash content, usage, and misc. installation variables).
(To be preformed by a certified technician).
PAGE 30
Profile 30 FS – Opening Side Panels
Profile 20 FS – Using a ¼" nut driver remove the #8 TEK
screw located at the front top of the panel (see following
picture). Reinstall screw to prevent panel from opening
accidentally!
Profile 20 FS – Opening Side Panels
#8 TEK
MOTOR LUBRICATION
The blowers are permanently lubricated by the manufac-
turer. Do not apply oil to any part of the blower, doing so
may cause damage.