Whitfield Profile 20 FS Installation And Operation Manual page 10

INSTALLATION
   
30 INS (Only) – Install damper rod knob as
Profile
illustrated below and explained on page 9 (see, Install-
ing Surround Assembly – Profile
Install Damper Knob during Surround Installation (see
page 9)
Damper Locations
See 'Opening Side Panels', page 30 for instructions on
opening the side panels for models Profile

Profile 30 FS. See 'Installing Surround Assembly' for
instructions on side surround panel access for model
Profile 30 INS.

Profile 20 FS - The damper is located behind the right-hand
side panel.

Profile 30 FS - The damper is located behind the left-hand
side panel.

Profile 30 INS - The damper rod is located on the left sur-
round panel.
Damper Adjustment
It is very important to preset your damper prior to burn-
ing your pellet stove.
The damper plate contains nine notches spaced in 1/8"
increments that aid in positioning (see figures A & B).

30 INS).

20 FS &
PAGE 10
CLOSED
For initial setup, push the damper all the way in (when
facing the front of the stove, in is to the center of the
stove, and out is away from the center of the stove) and
slowly pull back three to four notches (see figure B).
This setting should provide an adequate air to fuel ratio
for most installations.
OPEN 4 NOTCHES
Fig. A
Fig. B