Connector; Programming Keys At First Start-Up; Programming New Keys - APRILIA PEGASO 650 STRADA Service Station Manual

Electrical system

Programming keys at first start-up

The customer is provided with two keys, both with transponder in the handgrip. The instrument panel
requests programming the keys when it is turned on for the first time.
The display shows the following message:
•
Insert the X key
•
X+1 key programmed
At least one key must be stored, for the next start-ups. If no other keys are inserted within 20 seconds
or if there is lack of power or after the fourth key is programmed, the procedure finishes and all the
functions of the vehicle and the instrument panel must be enabled (even if only one key has been
programmed).

Programming new keys

If one key is lost, the customer can disable the lost key or disable and replace the whole key set by
changing the key lock.
Diagnosis
The instrument panel should signal when the component related to the immobilizer function is mal-
functioning, the aerial is broken and a transponder reads a code different from the one stored, in which
case entering the access code is required.

CONNECTOR

The connector diagram on the instrument panel
and the relevant pin configuration are shown in the
figure.
The numbers are also stamped on the plastic part
of the connectors and also on the connector body.
The pin configuration of the grey-bodied connector
is as follows:
•
PIN 1: +KEY
•
PIN 2: RIGHT CONTROL INDICATOR
•
PIN 3: HIGH-BEAM LIGHTS INPUT
•
PIN 4:
•
PIN 5: HEATED HANDGRIPS INPUT
•
PIN 6: K LINE
•
PIN 7: NEUTRAL
•
PIN 8: SELECT 1 - DOWN
•
PIN 9: FUEL LEVEL SENSOR
•
PIN 10:
•
PIN 11: +BATTERY
•
PIN 12: LEFT CONTROL INDICATOR
ELE SYS - 50
PEGASO 650 STRADA - TRAIL - FACTORY