Table of Contents
Advertisement
2
Installation Instructions
An AP-7522 Access Point mounts either on a wall (with M 3.5 x 0.6 x 23 MM pan head
screws and mounting bracket- or equivalent) or on a suspended ceiling T-bar.
To prepare for the installation:
1 Match the part number on the purchase order with the part numbers in the packing list
and on the case of the Access Point.
2 Verify the contents of the box include the intended AP-7522 Access Point, and the
included hardware matches the package contents (see
page
6).
Part Number
AP-7522-67040-US
AP-7522-67040-1-WR
AP-7522-67030-US
AP-7522-67030-1-WR
3 Review site survey and network analysis reports to determine the location and mounting
position for the AP-7522 Access Point.
4 Connect a CAT-5 or better Ethernet cable to a compatible 802.3at or 802.3af power
source and run the cable to the installation site. Ensure there is sufficient slack on the
cable to perform the installation steps.
NOTE
When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6 cable is
recommended for Gigabit operation.
Precautions
Before installing an AP-7522 Access Point, verify the following:
• Your are using the correctly rated power solution for the AP-7522 (either the AP-
PSBIAS-2P3-ATR power injector or the PWRS-14000-54R external power supply)
• Do not install the AP-7522 in wet or dusty areas.
• Verify the environment has a continuous temperature range between -4° F to 104° F/-
20° C to 40° C for external antenna Access Points and 32° F to 104° F/0° C to 40° C for
internal antenna Access Points.
AP-7522 Installation Guide
Hardware Installation
Description
AP-7522 dual radio 802.11ac 2x2:2 MIMO Access Point external antenna
US version
AP-7522 dual radio 802.11ac 2x2:2 MIMO Access Point external antenna
International version
AP-7522 dual radio 802.11ac 2x2:2 MIMO Access Point internal antenna
US version
AP-7522 dual radio 802.11ac 2x2:2 MIMO Access Point internal antenna
International version
AP-7522 Package Contents on
7
Hide quick links:
Advertisement
Table of Contents
