Programming; Remarks About Programming - Philips CDR778 Instructions For Use Manual

Remarks about programming

• You can program up to 99 tracks to play in any desired
sequence.
• Tracks can be programmed more than once, but each time
counts as a track.( )
STEP
• A program for playback can be made from both the disc in
the recorder deck and the disc in the player deck. A program
for recording can only be made from the disc in the player
deck.
Programming for playback
1 Select Changer mode or DJ mode using the DJ MODE key.
CHANGER or DJ MODE appears on the display.
2 Press CDR or CD to select the required deck.
Selected key lights up.
3 Press PROG(ram) to enter Program mode.
flashes and PROGRAM followed by track
PROG
information appears on the display.
REM REC TIME TRACK TOTAL
1 2 3 4 5 6 7 8 9 10 11
SYNC MANUAL
RECORD
CHANGER
DIGITAL I CD
OPTICAL I
RW
ANALOG
REM REC
TIME TRACK TOTAL
1
SYNC MANUAL
RECORD
DIGITAL I CHANGER
CD
OPTICAL I
RW
ANALOG
4 Select the required track numbers by turning the EASY
JOG/ENTER key left or right and store by pressing ENTER.
REM REC TOTAL
TIME TRACK
2 7 8 11
SYNC MANUAL
RECORD
DIGITAL I CHANGER
CD
OPTICAL I
RW
ANALOG
or:
Key in a track number with the number keys on the remote
control and press ENTER to confirm. For 2-digit numbers,
press the keys in rapid succession.
The track will be stored in the program.
The track number, total program time and the number of
programmed tracks (
STEPS
5 Repeat step 4 for all tracks to be programmed.
6 Press STOP or PROG(ram) to end programming.
lights continuously.
PROG
7 Press PLAY/PAUSE 2 ; to start programmed play.
REM TRACK TIME STEP
PROG
SHUFFLE ALL
CD
REPEAT
RW
SCAN TRACK
TRACK TIME STEP
REM
PROG
SHUFFLE ALL
CD
REPEAT
RW
SCAN TRACK
REM TRACK TIME STEP
PROG
SHUFFLE ALL
CD
REPEAT
RW
SCAN TRACK
) are displayed.
Programming for recording
1 Press RECORDING-TYPE to select the required recording
mode (see 'Recording').
2 Compile your programme as described in "programming for
playback". (steps 3 to 5)
• Only tracks from the disc in the CD player can be stored.
3 Press RECORDING-RECORD to start recording.
Note:
- To review the program, press PROG(ram), followed by 5 or
6 with the CD player or CD recorder in stop mode.
- To add more tracks to the program, repeat steps 1 to 7.
- If you try to store more than 99 tracks, PROG FULL
appears on the display.
Clearing a program
1 Press STOP 9 if necessary to stop programmed play.
2 Press STOP 9 again to clear the program.
disappears from the display.
PROG
• The program is also cleared if you open the disc tray.
Erasing a track from a program
1 In Stop mode press PROG(ram) to enter Program mode.
2 Use 5 or 6 to select the track that has to be deleted.
The track number and program step will be shown on the
display.
3 Press CANCEL/DELETE to erase the track from the program.
The remaining program steps and the remaining playing
time of the program will be displayed.
4 Repeat step 2 and 3 for all tracks to be erased.
5 Press STOP 9 or PROG(ram) to end erasing.
lights continuously.
PROG

PROGRAMMING

25