Playing; Selecting A Track Or Searching; Shuffle Play; Repeat Cd, Track Or Program - Philips CDR 760 Instructions For Use Manual

Selecting a track or searching

C D - R
E C O R
D A B L
E / R E
W R I T
A B L E
P ow er O
n/ O ff
Selecting a track during play
1 Briefly press ∞ or § one or more times.
➜ Play skips to the beginning of the present, previous or
following track.
or
• Press the required track number using the numerical keys
on the remote control. For 2-digit track numbers, press the
keys in rapid succession.
➜ Play skips to the beginning of the selected track.
Selecting a track when CD play is stopped
1 Briefly press ∞ or § one or more times.
2 Press PLAY.
➜ Play starts at the selected track.
or
• Press the required track number using the numerical keys
on the remote control. For 2-digit track numbers, press the
keys in rapid succession.
Searching during CD play
1 Hold down ∞ or § (or 5 or 6 on the remote control).
➜ The player first searches backwards or forwards at 10
times normal speed with sound at low volume, then
goes to fast reverse or fast forward with sound muted.
2 Release the button at the desired passage.
➜ Play starts at the desired passage.
Note: During Shuffle, Repeat or Program play, search is
restricted to within the track being played at the time.

Shuffle play

1 Press SHUFFLE (or PLAY) on the remote control before or
during CD play to start shuffle play.
➜ The tracks on the CD (or program if set) play in random
order. SHUFFLE will appear on the display between
tracks.
2 Press SHUFFLE again to return to normal CD play.
Note: Shuffle is also cleared when you open the disc tray.

Repeat CD, track or program

1 Press REPEAT on the remote control one or more times
during CD play.
➜ When
R EC O R D
FI N A LI ZE
ER A S E
2 To return to normal play, press REPEAT one or more times
until:
Re co rd ab
le
➜ the
Note:
- You can use shuffle in combination with repeat CD or
program play.
- Repeat is also cleared when you open the disc tray.

Programming

You can program up to 30 tracks to play in any desired
sequence. Tracks can be programmed more than once, but
each time counts as a track.
1 On the remote control press PROGRAM to start
programming.
➜
2 Press a track number with the number keys. For 2-digit
numbers, press the keys in rapid succession.
➜ On the display, the track number appears briefly,
3 Repeat step 2 for all tracks to be programmed.
4 Press STOP or PROGRAM to end programming.
➜
Note:
- To review the program, press ∞ or § in stop mode.
- To add more tracks to the program, repeat steps 1 through
4.
- If you try to store more than 30 tracks, FULL appears on
the display
5 Press PLAY to start programmed play.
Clearing a program
1 Press STOP if necessary to stop programmed play.
2 Press STOP again to clear the program.
➜
Note: The program is also cleared when you open the disc
1 appears on the display, the current track
REPEAT
plays repeatedly. When appears on the display,
REPEAT
the disc or program plays repeatedly.
message disappears from the display.
REPEAT
flashes on the display.
PROG
followed by the total programmed tracks and total
program time.
lights continuously.
PROG
disappears from the display.
PROG

PLAYING

17