Manually Raising The Transducer - Furuno CHS-5LMARK-2-55 Operator's Manual

8.3.2

Manually raising the transducer

If the transducer can not be raised automatically, manually raise it as follows:
1. Turn off the POWER switch on the hull unit.
2. Remove four screws (M4x8) to remove the gear cover.
3. Remove two screws (M4x12) to unfasten the attachment.
4. Fasten the attachment onto the motor gear with the screws removed at step 3.
5. Turn the attachment clockwise with the ratchet wrench to raise the transducer.
CAUTION CAUTION
Turn off the POWER switch on the hull
unit before manually raising or lowering
the transducer (with the ratchet wrench).
Bodily injury may result if the ratchet
wrench rotates unexpectedly, because the
raise/lower motor may start up.
Gear cover
Screw
(M4x8, 4 pcs.)
Raise/lower drive
assembly
POWER switch
Fasten the attachment onto
the motor gear.
8. MAINTENANCE, TROUBLESHOOTING
Gear cover
Screw Screw
(M4x12, 2 pcs.) (M4x12, 2 pcs.)
Turn the attachment
clockwise with
the ratchet wrench.
Motor gear
Attachment
8-3